12
Place the next three logs on the ember bed as shown.
Next place log “K” on the right side of the ember bed. Log “O” is placed so that it is resting on log “P”. The placement of logs “P”
and “O” is important as a flame will be projected on the log.
To finish the installation, sprinkle the vermiculite and lava stones over the ember bed. First place the lava stones between and
around the logs. Then sprinkle vermiculite over the entire ember bed as well as on the floor plate around the ember bed. If too
much vermiculite is placed on the ember bed the light of the ember bed will not be visible.
It is suggested that after the glass reflector is placed in the next installation step that the fireplace is turned on. This will allow the
flames to be visible. The “P” and “O” logs can then be adjusted if needed to line up with the flame.
To Next Page
Loading...