11
Start the log set installation by placing the first three logs on the ember bed as shown. Place lava stones on the ember bed around
these three logs.
Next place the two larger logs “A” and “B” on the stands at the rear of the fireplace. These logs have cut outs on them that will fit
over the stands. Place the smaller logs “E” and “I” on the ember bed as shown.
Before placing more logs sprinkle the vermiculite over the ember bed. There should be a light covering of vermiculite over the
entire ember bed as well as on the floor plate around the ember bed. If too much vermiculite is placed on the ember bed the light
of the ember bed will not be visible.
Finish the installation by placing the final five logs. Take special care when placing log “F”. The tip of this log should be resting
between the two rear logs “A” and “B”. The fire is projected on the tip of the “F” log in this location if the log is not placed far
enough back the fire will be floating and not on the log.
It is suggested that after the glass reflector is placed in the next installation step that the fireplace is turned on. This will allow the
flames to be visible. The “F” log can then be adjusted if needed to line up with the flame.
To Next Page
Loading...
Need help?
General
