ALTERNATE CONTROLS
These controls are accessed by holding down the Engage footswitch
while turning the knob.
Gate
The Gate control adjusts the noise reduction threshold. Fully counter-clockwise is
o. Set the Noise Gate as follows:
1. Press and hold the Engage switch.
2. Start with the Gate knob fully counter-clockwise.
3. Slowly turn the knob clockwise until the noise attenuates. Stop and release
the switch.
Tightness
The Tightness control adjusts a pre-gain high-pass filter. Increasing this control
will tighten the low end with high-gain settings. Increase the Low control to
compensate for any reduction of low frequencies.
Presence
The Presence control adjusts a post-gain low-pass filter.
FOOTSWITCHES
Preset
The Preset switch selects a stored preset. The LED illuminates when a preset is
selected. For more information, refer to the Using Presets section.
Engage
The Engage switch selects between engaged and bypassed. The LED illuminates
when the pedal is engaged.
To Next Page
Loading...
