Need help?Do you have a question about the New Holland 8970 and is the answer not in the manual?
General| Type | Tractor |
|---|---|
| Engine Type | Diesel |
| PTO Power | 240 hp |
| Hydraulic Flow | 113.6 L/min |
| Fuel Capacity (L) | 379 L |
| PTO Speed | 1000 rpm |
| Transmission | Full power shift |
Provides general information, safety precautions, and tractor identification details.
Covers the tractor's cooling system, including components, operation, and troubleshooting.
Details the tractor's air induction system, including air cleaner, turbocharger, and intercooler.
Explains the tractor's fuel system, covering components, testing, and adjustments.
Continues the discussion on the tractor's fuel system, including specific components and procedures.
Outlines the procedures for removing the tractor engine from the chassis.
Details the steps for removing and installing the tractor's fuel tank.
Introduces the transmission system, its operation, and components.
Describes the process of separating the engine and front axle from the transmission assembly.
Details the procedure for detaching the rear axle from the transmission unit.
Covers the mechanical components and systems within the tractor transmission.
Explains the hydraulic system of the transmission, including controls and calibration.
Details the electrical systems related to the tractor transmission, including diagnostics.
Covers the four-wheel drive clutch system, its operation, and service.
Describes the Dana axle for four-wheel drive, including its components and adjustments.
Continues the information on the Dana four-wheel drive axle, covering serviceability and repair.
Details the Dana Supersteer linkage system, its operation, and adjustments.
Explains the Carraro axle for four-wheel drive, covering disassembly, assembly, and adjustments.
Covers the rear drive axle assembly, including operation, components, and repair.
To Next Page