4 - OPERATING INSTRUCTIONS
HST model
WARNING
Avoid injury! Always do the following before lubricating, maintaining, or servicing the machine.
1. Disengage all drives.
2. Engage parking brake.
3. Lower all attachments to the ground, or raise and engage all safety locks.
4. Shut off engine.
5. Remove key from key switch.
6. Switch off battery key, if installed.
7. Wait for all machine movement to stop.
Failure to comply could result in death or serious injury.
W0047A
To park the tractor carry out the following procedures:
1. Release the HST forward or reverse pedal (1) slowly
and depress the brake pedals (2). Pull the hand throt-
tle lever (3) rearward to reduce the engine speed.
NOTE: Park the tractor on a level surface, if it is nec-
essary to park on a slope, place the range gear shift
lever in the lowest gear and place chocks or blocks in
front or behind the tires depending on the direction of
the slope.
2. Make sure the PTO switch (4) is in the "OFF" position.
3. Push the HPL control lever (5) forward to lower imple-
ments (if equipped) to the ground. Turn the key (6) to
the "STOP" position.
4. Engage the park brake (7) and release the brake ped-
als slowly.
NHIL15CT00665AA 3
NHIL15CT00591AA 4
4-52
To Next Page
Loading...
Need help?
General
