What to do if my New Holland Tractor engine is overheating?
If your New Holland Tractor's engine is overheating, start by checking the radiator screen for grass or debris and clean it as needed. Ensure that the coolant level is adequate and add coolant if necessary. Inspect the fan belt for slippage or breakage; adjust the tension or replace the belt if required.
What to do if the start motor rotates but the New Holland Tractor engine doesn't start?
If the start motor rotates but the engine doesn't start on your New Holland Tractor, the battery charge might be low, so charge or replace it. There may be air in the fuel system, which requires bleeding. Also, the fuel filter could be clogged, so clean or replace it.
Why won't the start motor rotate on my New Holland Workmaster 25S?
If the start motor on your New Holland Tractor doesn't rotate when you turn the key, several issues could be at fault. First, make sure the forward or reverse pedals are in neutral and that the Power Take-Off (PTO) shift lever is in the “rear” position with the PTO switch off. A low battery charge can also prevent the motor from starting, so charge or replace the battery. Check for loose battery or starter cable terminals and tighten them if necessary. The key switch itself or the starter motor could be faulty, requiring repair or replacement.
Why is the battery charging indicator on in my New Holland Workmaster 25S Tractor?
If the battery charging indicator light stays on during operation of your New Holland Tractor, check for bad electrical connections at the battery terminals and ground, and repair as needed. The alternator or the battery itself may be faulty and require repair or replacement. Also, check the fan belt tension and replace the belt if it's broken or has incorrect tension.
Why is the engine oil pressure light on in my New Holland Workmaster 25S Tractor?
If the engine oil pressure indicator light is on during operation of your New Holland Tractor, it could be due to a lack of engine oil, so add oil as needed. Low viscosity of the engine oil can also trigger the light, so replace the oil with the proper viscosity type. A faulty pressure switch or a clogged engine oil filter can also be the cause; replace the switch or the filter accordingly.
Why is the engine speed irregular on my New Holland Workmaster 25S Tractor?
Irregular engine speed in your New Holland Tractor can be caused by several factors. Air in the fuel system may be the issue, requiring you to bleed the fuel system. A clogged fuel filter can also cause this problem, so clean or replace the filter. Additionally, check for fuel leaks and replace fuel lines if needed.
Why is the exhaust gas black on my New Holland Workmaster 25S Tractor?
Black exhaust gas from your New Holland Tractor may indicate a clogged air filter, so clean or replace it.
How to troubleshoot a three-point linkage that won't raise on my New Holland Tractor?
If the three-point linkage on your New Holland Tractor won't raise, first ensure the engine speed is at least 1500 RPM. Check if the hitch is overloaded and reduce the load if necessary. Also, check the transmission/hydraulic oil level and add oil if needed. Inspect the hydraulic filter and all hydraulic suction connections, tightening the filter and connections as necessary.
Why won't the headlights illuminate on my New Holland Tractor?
If the headlights on your New Holland Tractor won't illuminate, start by replacing any burnt-out light bulbs. Check for blown fuses and replace them with the correct size. Inspect the headlight wiring connection and repair as needed. If the problem persists, the light switch may be faulty and need replacement.
Why is the HST power low on my New Holland Workmaster 25S?
If the HST power is low on your New Holland Tractor, first reduce the load on the tractor. Check the transmission oil level and add oil as needed. Inspect the hydraulic suction line and repair if there is air in the HST circuit. Replace the HST filter if it is clogged.
Defines the tractor's designed purpose and operational limitations to prevent misuse.
Safety and pre-operation checks specific to tractors with a cab.
Locates identification plates essential for service and parts.
Defines the tractor's views (front, rear, left, right) from the operator's perspective.
General safety precautions for operation, including slope safety and fluid handling.
Identifies safety signs related to the ROPS and their importance.
Identifies safety signs specific to the tractor's cab for safe operation.
Identification and function of primary controls located in the forward area.
Details the various indicators and gauges on the instrument panel.
Operation of the ignition switch for starting, preheating, and powering down the tractor.
Procedure for engaging and releasing the park brake for secure parking.
Operation of the differential lock for enhanced traction, including steering considerations.
Guidelines for the initial break-in period to ensure engine longevity and performance.
Safe procedures for refueling the tractor's fuel tank, including precautions.
A step-by-step guide for safely starting the tractor's engine.
Explanation of how to operate the HST, its ranges, and speed control.
Procedures for safely parking the tractor, including park brake application.
General safety guidelines and considerations for driving the tractor on public roads.
Method for securing the tractor when loading and unloading onto transport.
How to operate the tractor's turn signals, hazard, headlights, sidelights, and brake lights.
Step-by-step instructions for folding and unfolding the ROPS for transport or low clearance.
How to operate the three-point hitch system to raise and lower implements.
How to engage, disengage, and operate the rear, mid, and combined PTO.
A schedule detailing required maintenance actions and intervals based on operating hours.
Procedure for changing the engine oil and filter at specified intervals.
Steps for replacing the main fuel filter element to ensure fuel system integrity.
Importance of maintaining correct tire pressure and guidelines for checking.
Procedure for changing the transmission, rear axle, and hydraulic fluid.
Protective measures to take when storing the tractor for an extended period.
Diagnosing and resolving common engine-related problems and their causes.
Identifying and fixing issues related to the tractor's steering system.
Troubleshooting guide for problems encountered with the HST operation.
Steps to diagnose and resolve issues within the tractor's electrical system.
Comprehensive technical data for the tractor's engine, capacities, and systems.
Specific dimensions related to the ROPS, wheel tread, and ground clearance.
Checklist for dealers to confirm pre-delivery service completion and machine readiness.
A checklist for owners to review the pre-delivery service and familiarize themselves with the machine.
General| Engine Type | 3-cylinder diesel |
|---|---|
| Engine Power | 24.7 hp |
| Transmission | Hydrostatic |
| Fuel Capacity | 6.6 gallons |
| Drive Type | 4WD |
| PTO Speed | 540 rpm |
To Next Page