EasyManua.ls Logo

New Holland Workmaster 60 - User Manual

New Holland Workmaster 60
184 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATOR’S MANUAL
Part number 47690424
1
st
edition English
May 2015
Workmaster
™
50
Workmaster
™
60
Workmaster
™
70
Tractor

Table of Contents

Other manuals for New Holland Workmaster 60

Preview: Service Manual
Service Manual1067 pages

Questions and Answers

  • A
    Abigail RodriguezAug 14, 2025
    Why my New Holland Workmaster 60 Tractor engine does not start?
    • B
      beckercoreyAug 14, 2025
      If your New Holland Tractor's engine won't start, it could be due to several reasons. There might be air in the fuel supply circuit, requiring bleeding. The injectors could be dirty or faulty, needing replacement. A faulty fuel pressure regulation valve or a failure of the start control could also be the cause, both requiring replacement. Alternatively, there might be water and/or impurities in the fuel, or the fuel filter could be clogged, requiring a filter replacement.
  • M
    Matthew HuntAug 17, 2025
    What to do if New Holland Workmaster 60 control board and engine do not start during ignition?
    • B
      Bailey RosalesAug 18, 2025
      If the control board and engine of your New Holland Tractor fail to start during ignition, the issue might stem from a flat battery, in which case you should recharge or replace it. Another potential cause is a blown fuse, which necessitates replacement. Also, check the electric connections to ensure they are properly connected. A failure of the engine revolution sensor may also be the cause, requiring a replacement.
  • A
    Alison ParkerAug 20, 2025
    What to do if coolant temperature warning light comes on in New Holland Tractor?
    • E
      Evan EllisAug 20, 2025
      If the coolant temperature warning light activates on your New Holland Tractor, make sure the engine coolant level is correct by adjusting it. Another potential cause is a stuck overpressure valve of the load plug, which requires replacing the plug.
  • M
    Micheal WellsAug 25, 2025
    Why does my New Holland Workmaster 60 engine stop after ignition?
    • A
      Alexa SchultzAug 25, 2025
      If your New Holland Tractor engine stops shortly after starting, it could be due to a few reasons. There might be air in the fuel supply circuit, requiring bleeding. A clogged fuel filter can also cause this issue, so replace the filter. A faulty fuel pressure regulation valve may also be the cause and needs replacement. Also, water and/or impurities in the fuel can cause the engine to stop.
  • C
    christine39Aug 27, 2025
    What to do if my New Holland Tractor engine does not reach the operating speed?
    • J
      Jerome BlackAug 27, 2025
      If your New Holland Tractor engine struggles to reach operating speed, several factors could be responsible. A clogged fuel filter might be restricting fuel flow, so replace the filter. The presence of air in the fuel supply circuit could also be a factor, requiring bleeding. Dirty or faulty injectors may also cause this issue, so consider replacing them. A clogged air filter, which requires cleaning or replacement, could also be the cause. Overload can prevent the engine from reaching its operating speed, so reduce the load.
  • V
    vicki80Aug 30, 2025
    How to fix output reduction in New Holland Workmaster 60 Tractor?
    • L
      Lisa WilliamsAug 30, 2025
      If you're experiencing a reduction in output from your New Holland Tractor, consider these potential causes: A clogged fuel filter could be restricting fuel flow, so replace it. Air in the fuel supply circuit might be the issue, requiring bleeding. Dirty or faulty injectors may also cause this issue, so consider replacing them. A clogged air filter could be the cause, clean or replace the filter. If the particulate filter is clogged, the particulate filter regeneration is necessary.
  • P
    Peter BrownSep 3, 2025
    What causes the starter motor to not run on a New Holland Workmaster 60 Tractor?
    • N
      njohnsonSep 3, 2025
      If the starter motor on your New Holland Tractor isn't running, it could be due to a flat battery, so recharge or replace it. Also, check the electric connections to ensure they are secure and uninterrupted.
  • J
    Justin RobertsSep 6, 2025
    What to do if pressure gauge shows low engine oil pressure in New Holland Workmaster 60 Tractor?
    • T
      Timothy GordonSep 6, 2025
      If the pressure gauge on your New Holland Tractor indicates low engine oil pressure and the warning light is on, check the oil level and adjust if it is too low. The engine oil filter may also be blocked, so replace the engine oil filter.
  • R
    richard00Sep 9, 2025
    Why the electrical system does not work in New Holland Workmaster 60 Tractor?
    • S
      Shawn AndersonSep 9, 2025
      If the electrical system on your New Holland Tractor isn't working, start by checking the battery terminals for looseness or corrosion, and clean and tighten them if necessary. A discharged battery could also be the problem, so charge or replace it. Also, a fusible link wire failure can cause the electrical system to fail, so check for the cause of failure and replace the fusible link.

Summary

SAFETY INFORMATION

Safety rules

General guidelines and precautions for safe operation and maintenance of the tractor.

Operator protective structure

Information on the importance and use of the ROPS for operator safety.

CONTROLS AND INSTRUMENTS

OPERATING INSTRUCTIONS

Starting the tractor

Step-by-step procedure for safely starting the tractor engine.

Shut off the engine

Procedure for safely stopping the tractor engine and securing the machine.

TRANSPORT OPERATIONS

WORKING OPERATIONS

POWER TAKE OFF (PTO)

THREE POINT LINKAGE

HYDRAULIC SYSTEM

MAINTENANCE

MAINTENANCE CHART

After the first 50 hours of operation

Hydraulic oil filter

TROUBLESHOOTING

Engine - Troubleshooting

Common engine problems, their causes, and recommended corrections.

Electrical systems - Troubleshooting

Troubleshooting steps for common electrical system issues.

Hydraulic systems - Troubleshooting

Diagnosing and resolving problems with the tractor's hydraulic systems.

SPECIFICATIONS

Transmission speeds (8 X8)

New Holland Workmaster 60 Specifications

General IconGeneral
Engine Power60 HP
Transmission8x8 Synchro Shuttle
Lift Capacity2, 756 lbs
Hydraulic SystemOpen center
PTO Speed540 RPM
3-Point HitchCategory I
Fuel Tank Capacity13.2 gal

Related product manuals