New Holland CX Series User Manual

QUICK REFERENCE CARD – NEW HOLLAND CX COMBINES
Form 147074 Rev. E (E27025) Page 3 of 4
973/2052 & 974/2062/84C Initial Set-up
Rice Soybeans
Average Cereal Crops
Normal Cutting
Tough Cutting Dry Conditions
Wet
Conditions
Sickle- Check daily that guards are
aligned. Clearance from hold down
to sickle 0.020” (0.5mm)
- - -
-
2100 reel Fore/Aft- 4 or 5 on decal
Finger Pitch Adjustment- Slot 5
Reel Clearance- 5/8” (15mm) for
973/2052 headers and at hinge
points for 974/2062/84C headers in
full frown. Refer to 973/974
Operator’s Manual.
Speed- +10 % ground speed.
5
-
-
-
7
-
-
-
6
Slot 7
½” (13mm)
-
6
Slot 7
½” (13mm)
-
Draper Speed- Dial position “4”.
Draper opening- 55” (1410 mm)
Reduce opening if side drapers are
back feeding.
-
-
Position 3 or 4
50.6” (1285 mm)
-
-
-
-
Guard Angle- center link 19-¼”
(490 mm) length (pin to pin).
Poly Skids- Optional on 973/2052
-
Yes
-
Yes
-
Yes
Center link fully
retracted.
Yes
Gauge Wheels (if equipped)-
Most cereals require “medium”
stubble height setting
Note: Gauge wheels should be in
storage position for on the ground
cutting applications.
Not Applicable Not Applicable Storage Storage
Float- Adjust float to achieve 0” gap
at downstop pad. (Refer to 873
Operator’s Manual)
½” gap ½” gap ½” gap ½” gap

New Holland CX Series Specifications

General

Category	Combine Harvester
Header Width	Up to 12.5 meters
Transmission	Hydrostatic
Series	CX Series
Engine	FPT (Fiat Powertrain Technologies)
Threshing System	Axial-Flow
Cleaning Area	Up to 6.5 m²
Fuel Tank Capacity	Up to 1, 000 liters
Wheel Options	tracks
Models	CX5, CX6, CX7, CX8