SECTION 1 – GENERAL INFORMATION AND SAFETY
1–10
Operating the combine
1. Before operating the combine ensure that all
safety guards are properly fitted and secured.
2. Never attempt to clean, lubricate or carry out any
adjustments on the combine while it is in motion
or while the engine is running.
3. For safety’s sake never leave the operator’s plat-
form without first disengaging the combine drive
mechanism, lowering the header, stopping the
engine, applying the handbrake and removing the
ignition key.
4. Never climb on or off the machine when it is in mo-
tion as there is a risk of being run over.
5. Use extreme caution when operating close to the
edge of a ditch or a steeply dropping embank-
ment.
6. Avoid changing direction abruptly, especially
when reversing, to avoid dangerous pitching of
the machine. Lower the attachment if the ma-
chine tends to lift at the rear.
7. Always operate the combine at a safe speed in
accordance with the ground conditions.
On uneven ground, proceed with the utmost cau-
tion to ensure proper stability.
8. When operating on gradients, never drive too
fast, especially when turning.
9. Danger of death by electrocution!
Pay special attention to the overhead power
lines. Make sure the machine has sufficient
clearance to pass in all directions (also with
raised or opened machine components). Also
think of the radio aerial(s) or any other factory–
fitted accessory or parts which may have been
added afterwards.
Should a contact between the machine and an
electric power line occur, then the following
precautions must be taken: Stop the machine
movement immediately, stop the engine and
apply the handbrake.
Check if you can safely leave the cab or your
actual position without direct contact with electric
wires. If not, stay in your position and call for help.
If you can leave your position without touching the
lines, jump off the last step or support position to
ensure that there is no contact between any part
of your body and the ground at any time. Never
touch the machine afterwards until power to the
lines has been shut off. When people approach
the machine, warn them not to touch the machine
but to ask the electric power supply company to
shut off the power to the lines.
10. Never apply the differential lock when turning.
When engaged, the differential lock will prevent
the combine from turning.
11. Ensure the engine is shut off and wait until the
machine has completely stopped before opening
any of the guards.
THERE ARE ROTATING PARTS UNDER THE
GUARDS WHICH MAY CONTINUE ROTATING
AFTER THE MACHINE HAS BEEN STOPPED.
Look and listen for evidence of rotating parts
before opening any of the guards.
To Next Page
Loading...
Need help?
General
