Need help?Do you have a question about the New Holland Electro Command S T5.110 and is the answer not in the manual?
General| Engine Power | 110 hp |
|---|---|
| Transmission | Electro Command Semi-PowerShift |
| Hydraulic System | Open Center |
| Hydraulic Remotes | Up to 3 |
| Weight | 4400 kg |
| Fuel Tank Capacity | 165 liters |
| PTO Speed | 540/540E/1000 |
| Rated Engine Power | 110 hp |
Information on adjusting the operator's seat and seat restraints.
Procedures for commissioning the tractor unit, including engine and fuel tank.
Instructions for starting the engine starting system.
Guidance on stopping the engine and operating the battery isolator.
Steps for starting the engine and operating the tractor.
Safety rules for remote control valves.
Operating and adjusting two-speed rear PTO, including safety messages.
Safety rules and operating instructions for the rear hydraulic lift.
Initial maintenance tasks like tightening, checking, replacing, cleaning, testing, and greasing.
Replacing oil filters, checking transmission housing, and greasing steering parts.
Engine replacement, fuel filter replacement, and wheel tightening.
Replacing cab filters, air cleaner, greasing wheel hubs, and draining fuel tank.
Changing fluid for final drive, 4WD axle, transmission, and radiator.
Procedure for calibrating the PTO clutch.
Information on instrument cluster part identification and general specification.
Troubleshooting by symptom for engine, electrical system, transmission, hydraulics, and cab.
Warning against tampering with the engine and fuel system due to emissions standards.
California Proposition 65 warning regarding diesel exhaust and battery components.
Explanation of tractor safety functions controlled by sensors and warnings against bypassing them.
To Next Page