To Next PageTo Next Page
Need help?Do you have a question about the New Holland Auto Command T7.220 and is the answer not in the manual?
General| Model | T7.220 Auto Command |
|---|---|
| Transmission | Auto Command CVT |
| Cylinders | 6 |
| PTO Speed | 540/1000 RPM |
| Maximum Speed | 50 km/h |
| Engine | NEF 6.7L |
| Hydraulic Remotes | Up to 4 rear remotes |
| Wheelbase | 2, 884 mm |
Describes the division of the manual into sections and chapters.
Explains the SAP coding system for locating technical information.
Details safety alert symbols, signal words, and personal protection requirements.
Torque values for metric non-flanged hardware.
Torque values for metric flanged hardware.
Torque values for inch non-flanged hardware.
Torque values for inch flanged hardware.
Details methods for identifying the grade of inch lock nuts.
Installation and torque for fittings in O-ring boss configurations.
Installation and torque specifications for ORFS fittings.
Approved biodiesel fuel blends and usage conditions.
Lists fluid capacities for various tractor systems.
Engine oil viscosity grade selection based on ambient temperature.
Approved biodegradable oil for transmission and hydraulics.
Effect of fuel sulphur content on oil change intervals.
Coolant specifications and water quality requirements.
Recommendations for brake oil, AC oil, and grease.
Details the engine and crankcase components and procedures.
General engine specifications and required special tools.
Procedures for electrical testing of engine sensors using DATAR equipment.
Steps for disconnecting engine components before removal.
