www.newair.com 12
OPERATING INSTRUCTIONS
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check that ice basket and ice
scoop is included. If any parts are missing, please contact our customer
service.
2. Clean the interior with lukewarm water and a soft cloth. Take out the ice
basket and clean it
3. Find a location for your ice maker that is protected from direct sunlight
and other sources of heat (i.e.: stove, furnace, radiator). Place the ice
maker on a level surface. Make sure that there is at least 6 inches of space
between the back and sides of your ice maker and the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging ice maker
in.
5. The appliance must be positioned so that the plug is accessible.
WARNING: fill with potable water only.
CONNECTING YOUR ICE MAKER
DANGER: Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of
this appliance is equipped with a three-prong plug which mates with
standard three prong wall outlets to minimize the possibility of electric
shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall
outlet. Do not under any circumstances, cut or remove the third (ground)
prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician.
3. This appliance requires a standard 110-120volt, 60Hz electrical outlet with
three-prong ground.
To Next Page
Loading...
Need help?
General
