NewAir NIM045SS00 User Manual

EN
www.newair.com 18
TROUBLESHOOTING
Problem
Possible Causes
Solution
< > is on
Lack of water
Turn off the unit and add
water to <FULL>level, then
re-start the unit.
< > is on
Too much ice in the ice
basket
Remove the ice cubes in the
basket
The water reservoir
has water, but<
> is on
The inlet solenoid valve
breakdown
Need the technical service
person to maintain
<E1> is on
Ambient temp sensor
breakdown
The unit can still work,
change to a new sensor
<E2> is on
Water temp sensor
breakdown
The unit can still work,
change to a new sensor
No water in the
water Separator
pipe
The holes are blocked
Use slim wire to prick each
hole, till
The water can flow out
easily.
Water filter block
Clean the water filter
Ice cube are too
thick and can’t Drop
down
Ice making cycle too long
Press <->to reduce the ice
making
time.
Ice cube thin
Ambient temp too high
Move the unit to cool place
Water temp too high
The water temp should be
no more than 77 F (25 C).
Ice making time too short
Press<+>to increase the ice
making Time.
Unit work but no ice
cube
Ambient temp is high or the
Water temp is high
Move the unit to
somewhere ambient Temp
lower than 86 F (30 C), fill
cool water.
Refrigerant system
leakage
Need the technical service
person to
maintain
Refrigerant system block
Need the technical service
person to
maintain

NewAir NIM045SS00 Specifications

General

Brand	NewAir
Model	NIM045SS00
Category	Ice Maker
Language	English