CONEX-CC Controller GUI Manual
Configurable settings
The following table describes all the settings that can be changed by the user.
Trace is the most detailed of the settings and when this
setting is selected the Controller GUI logs everything.
Critical Error is the least detailed of the settings and when
this setting is selected the Controller GUI will only log
errors that are defined to be critical.
Detail
Equipment Message
Info
Warning
Error
The polling interval defines the number of milliseconds
(delay) between each time the Controller GUI polls the
instrument for the latest information.
Number of fractional digits after the decimal point.
The delay defines the number of milliseconds between each
sent command from a text file.
MemorizePositionsRollingBuffer
BufferDepth defines the maximum number of
analog I/O values displayed in the chart.
Positions is a list of memorized positions. The format is
“Name of positions #1; X position #1; Y position #2…”
XAxis defines the instrument for X axis.
None = no instrument for X axis
YAxis defines the instrument for Y axis.
None = no instrument for Y axis
The communication channel
Specifies type of instrument connected to computer
Specifies number of instruments connected to computer
The axis direction for X axis.
The axis direction for Y axis.
The started sensibility defines the zoom level of the
tracking panel after Controller GUI launching.
The minimum amplitude for X axis.
The maximum amplitude for X axis.
The minimum amplitude for Y axis.
The maximum amplitude for Y axis.
The maximum incremental step when the tracking is in
incremental displacement mode.
To Next Page
Loading...
