CONEX-CC Controller GUI Manual
2.0 Installation
2.1 Install CONEX-CC Graphical User Interface
Following are steps to install CONEX-CC GUI.
• For 32 bit, Select and launch “CONEX-CC Utility Installer Win32.exe”. For 64
bit, Select and launch “CONEX-CC Utility Installer Win64.exe”.
• A window opens up showing Install welcome page.
• Click on “Next”.
• A window opens up allowing destination folder selection. By default it is showing
C:\.
• Click on “Next”.
• Ready to install window opens up. Click “Install”.
• Then installation starts, wait for completion. Click on “Finish” to finalize the
installation.
32 bit installer will be installed “Newport.CONEXCC.CommandInterface.dll” in
GAC_32 folder and 64 bit installer will be installed the dll in GAC_64 folder.
NOTE
LabVIEW user can add reference of command interface dll from GAC during VI
creation.
2.2 Launch GUI
From Windows “START” menu, select “All Programs\Newport\Motion
Control\CONEX-CC\CONEXCC Utility”.
3 EDH0277En1041 — 10/17
To Next Page
Loading...
