9
2.1.1 CONFIGURE CHANNELS
NC1 IO allows you to select different audio and video sources for each channel via the
Configure panel ( Figure 4). Click the gear next to the channel label below a viewport to
open its Configure panel (Figure 3).
INPUT TAB
FIGURE 4
The tabbed Input pane allows you to select audio and video sources for this channel, and set their format.
You can immediately choose any NDI or SDI connector configured as an input (the latter are shown in the
Local group), a webcam or PTZ camera with compatible network output, or even an input from a suitable
external A/V capture device. (Quad-link selections list the four associated SDI input numbers that will be
used, for reference.)
To Next Page
Loading...
Need help?
General