21
Programmer/Clock Continued....
To set the time of day
Press the ‘Plus’ and ‘Minus’ buttons
together for a few seconds, and
release.
The ‘’ in between the numbers on
the LED Display will begin to flash.
While the ‘’ is flashing it is possi-
ble to adjust the time using the ‘Plus’
and ‘Minus’ buttons. Once the time
has been set, allow approximately 30
seconds before using any of the other
timer functions. This ensures that the
time will remain correct.
To select an alarm tone
There are three tones to chose from.
Press the ‘Minus’ button to listen to
the first tone.
Release the ‘Minus’ button and press
it again to listen to the second tone
etc.
Releasing the ‘Minus’ button after the
tone has sounded will automatically
select that tone
Setting the minute minder
To set the Minute Minder, press the
‘Function’ button once. The bell sym-
bol will appear and start flashing. The
flashing only lasts for 5 seconds so the
time must be set within this time frame.
Use the ‘Plus’ and ‘Minus’ button to
set the length of time required. Once
this has been done, the Minute Minder
is set.
When the desired length of time has
counted down the alarm will sound.
To cancel the tone, press any of the
buttons.
To cancel the Minute Minder at any
time, press the ‘Function’ button, then
press the ‘Plus’ and ‘Minus’ buttons
together.
To Next Page
Loading...
