Nexa ZED 2951 - 8 Bluetooth Setting; Bluetooth HID Mode; Bluetooth HID Pairing

To Next Page

To Previous Page

8. Bluetooth Setting

8.1 Bluetooth HID Mode

Bluetooth HID Mode

*Remarks:

Scan this bar-code above to enter the“Bluetooth HID Mode”and it will connect the Bluetooth

which is matched last time automatically by default.

If not in broadcast state and need to pair the Bluetooth, please check below for more details.

8.2 Bluetooth HID Pairing

Bluetooth HID Pairing

1. 2 ways to enter “Bluetooth HID Pairing” mode:

(1) Scan the “Bluetooth HID Pairing” code, search for “Bluetooth” through the Bluetooth device.

(2) Pressing the button and hold for about 8 seconds, there will be a sound, then release the button.

2. Exit “Bluetooth HID Pairing” mode:

(1) When Bluetooth is matched, it will prompt once and ending pairing.

(2) After scan the “Bluetooth HID Pairing” bar-code, then Double-click the button, it will prompt

once.

(3) If the Bluetooth is not matched within 1 minute, it will exit automatically and with 3 beeps.

*Remarks:

When exiting pairing, if the new device is not connected, will connect to the device which is

matched last time automatically by default.