3.2 Data Transfer Mode
Normal Mode(*) Inventory Mode
Automatic Storage Mode
“Normal Mode”:
Data will be uploaded immediately, if data cannot save successfully, scanner will alarm.
“Automatic Storage Mode”:
Data will be saved automatically when the distance is exceeded.
Scan the "Upload All Data" bar-code to upload the data when the data need to check.
“Inventory Mode”:
Data will be saved automatically.
Scan the "Upload Statistical Data" bar-code when the statistical data need to be viewed or
uploaded.
*Remarks:
Scan the “Upload All Data” to upload the data, then scan the “Clear All Data ” to clear the data
first, otherwise the bar code read last time will be output again.
Clear All Data Upload Statistical Data
(
Amount of data
)
Upload All Data
*Remarks
“Clear All Data” is only effected under inventory mode.
To Next Page
Loading...