Nexans Euromold 200LR

To Next Page

• For indoor and outdoor applications.

• Only for cables NF C 33-226, UTE C 33-223, NF C 33-223 & HN 33-S-23 [Part 1],

NF C 33-220 (HN 33-S-22) with graphite coating screen [Part 2],

NF C 33-220 (HN 33-S-22) with extruded semi-conductive screen [Part 3].

• In case the ambient temperature is less then 0°C, it could be necessary to warm up the

sealing mastic and tape.

CAUTION : Read instructions thoroughly and completely prior to beginning installation.

Installation Instructions Separable Elbow Connector - CENELEC interface type A

(K)200LR

Up to 24 kV

Check if the diameter over cable core insulation is in accordance with

the cable reducer range as indicated in table below:

Cable reducer size

(see marking inside cable reducer)

200CA-12

200CA-16

13.0

17.5

21.0

25.0

Dia. over core insulation (mm)

min max

This product should be installed only by competent personnel trained in good safety practices involving

high voltage electrical equipment. These instructions are not intended as a substitute for adequate

training or experience in such safety practices. These instructions do not attempt to provide for every

possible contingency. Failure to follow these instructions could result in damage to the product and

serious or fatal injury. IMPORTANT : Cable and associated apparatus must be de-energised, locked

out, and tagged prior to product installation.

Page 1/9

IS97082-ENG - 200LR/G-MT345

15 January 2018 - Revision 0 - Supersedes edition of 3 June 2016

IS97082-ENG - 200LR/G-MT345 - Revision 0

Main Page

Need help?

Do you have a question about the Nexans Euromold 200LR and is the answer not in the manual?

Summary

Part 1. Cable Preparation for NF C 33-226;UTE C 33-223;HN 33-S-23

Cable Preparation and Screen Earthing

Details steps for preparing cables and earthing the screen according to specific standards.

Watersealing Procedure

Instructions for applying mastic and tape to seal the cable against moisture ingress.

Cable Reducer Installation

Steps for lubricating and fitting the cable reducer onto the cable.

Contact Tightening Procedure

Details on how to tighten the conductor contact until bolt heads shear off.

Connector Installation on Cable

Steps for cleaning, lubricating, and fitting the connector housing onto the cable reducer.

Connector Installation on Bushing

Instructions for cleaning, fitting the connector onto the bushing, and connecting earthing.

Part 2. Cable Preparation for Graphite Coated Screen NF C 33-220

Cable Preparation and Screen Earthing

Procedure for preparing cables with graphite coating and earthing the screen.

Part 3. Cable Preparation for Extruded Semi-conductive Screen NF C 33-220

Cable Preparation and Screen Earthing

Steps for preparing cables with extruded semi-conductive screen and earthing.