Nexgrill 720-0536 - User Manual

Questions and Answers

P
Paul MendozaJul 30, 2025
What to do if the rotisserie burner on my Nexgrill 720-0536 Grill won't light?
- C
  cstoneJul 30, 2025
  If the rotisserie burner on your Nexgrill Grill won't light when you push the igniter button: * Check for debris blocking the electrode. * See if a spark jumps from the electrode to the burner. If not: * Check the battery inside the igniter button by turning it counter-clockwise to open and remove it. * Gently bend the electrode closer to the burner until a spark is seen when you push the igniter button. * Check if the infrared back burner lights with a match. If not, ensure the gas is on.
J
Jasmine OrtizAug 4, 2025
Why does my Nexgrill 720-0536 take a long time to preheat?
- S
  Stephanie RobinsonAug 4, 2025
  A normal preheat for a Nexgrill Grill to reach 500-600 degrees takes about 10-15 minutes. Cold weather and wind may affect your preheat time. Also, using volcanic rock or briquettes can increase preheat time and maximum temperature.
A
Audrey PatelAug 8, 2025
What to do if my Nexgrill Grill only heats to 200-300 degrees?
- C
  Cathy BrownAug 8, 2025
  If your Nexgrill Grill is only reaching 200-300 degrees, there are several things you can check: * Ensure the fuel hose isn't bent or kinked. * Clear any dust from the grill area. * Clean the burner and orifices. * Inspect for spiders or insects. Additionally, the regulator might have a safety device restricting gas flow, even without a leak. To reset it, turn off all burners, close the LP tank valve, disconnect the regulator, wait one minute, reconnect it, slowly open the LP tank valve fully, then light all burners and monitor the temperature.
T
Terry LopezAug 12, 2025
Why are the burner flames on my Nexgrill 720-0536 Grill not light blue?
- H
  hamptonfrancisAug 12, 2025
  If the burner flames on your Nexgrill Grill aren't light blue, it could be due to: * Too much or not enough air mixture for the flame. * Elevation, which is the principal cause, or cold weather affecting the mixture, burner adjustment may be required. * The grill being in a windy location.
S
Shannon TaylorAug 16, 2025
Why won't the rotisserie motor on my Nexgrill Grill turn?
- H
  Henry ChavezAug 16, 2025
  If the rotisserie motor on your Nexgrill Grill isn't turning: * Make sure the motor is connected to a properly grounded power supply. * Ensure the on/off switch is in the on position. * Confirm the spit is fully inserted into the rotisserie motor. * Verify the load doesn't exceed the 40-pound operational capacity. * Check for any encumbrances or drag.
K
Kristin GibsonAug 21, 2025
Why is the regulator on my Nexgrill Grill making noise?
- J
  Justin DawsonAug 21, 2025
  If the regulator on your Nexgrill Grill is making noise: * The vent hose on the regulator may be plugged, or the regulator itself might be faulty. * Ensure the vent hole on the regulator is not obstructed. Clear the hole, close the gas control valves, wait ten minutes, and restart. * Check your flames for proper performance; if the flames are not correct, replace the regulator.
R
Robert RamirezAug 25, 2025
How to make my Nexgrill 720-0536 cover fit properly?
- N
  Nathan HowellAug 26, 2025
  If the full-size cover doesn't fit your Nexgrill Grill: * The cover may be incorrect for your grill model. Ensure it's the right length by measuring it left to right and comparing it to the grill's measurement. * Compare the location and size of the hood portion of the cover to your grill. * Spread the cover and allow it to relax, preferably in warm sunlight or a warm room. * For grills with a side shelf, bunch the cover like a sock and put it on from left to right.