1. Insert 1 x sprung wooden slat (4) through the first
hole in strap (7).
2. Attach single sided slat cap (5) onto one end of
the sprung wooden slat(4).
3. Insert sprung wooden slat and slat cap fitting from
Step 1 & 2, into the first gap in side rail 3.
4. Attach 1 x single sided slat cap (5) to the other
side of the slat and by lifting the centre and pushing
down on the end, insert the end of the slat (with
fitted cap) into the corresponding hole on the other
5. Repeat process for all remaining slats and caps
until all components have been used and firmly
pushed in place.
1. Attach 4 x finials(6) to headboard 1 turning
clockwise by hand to tighten.
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
1. Attach side rails 3 (x2) to headboard 1 and
footboard 2 using 8 x bolts (A), 8 x plastic washers
(B)
and 8 x metal washers (C). Tighten using Allen key
(D).
To Previous Page
Loading...
Need help?
General
