MENUS AND SETTINGS (CONTD.)
There is also a Setup menu for the general settings, press the MENU button twice on the rear of the device to
access the menu. The options and settings available are described below.
4.1 Format
Format the inserted memory card, this will delete all content.
4.2 Language
Set the language as required.
Default Setting: English
4.3 Date / Time
Adjust the date / time as required using the OK button to toggle through fields, and to set variables.
Note: In event of battery becoming fully dis-charged, the date will reset to 01/01/2013.
4.4 Frequency
Set the Frequency as required.
Default Setting: 50Hz
4.5 LED Light
Turn on the IR LEDs for enhanced nighttime recording.
Default Setting: Off
4.6 Beep Sound
Turn Off / On the beep sound, note if Beep is turned off the audible low-battery warning will also be disabled.
Default Setting: On
4.7 Screen Saver
Turn on the Screen Saver function, shut down the screen after a period of inactivity, press any button to re-open.
Default Setting: Off
4.8 TV Mode
Set the TV Mode as required.
Default Setting: PAL
4.9 Speed Stamp
Turn On / Off the Speed stamp shown on recorded files.
Default Setting: On
4.10 Version
Display the version number of your device’s software.
4.11 Default Setting
Reset the device to the default settings.
4.12 Auto Power Off
Adjust the timing of the Auto Power Off function, this can be used to continue recording in event of loss of
power within in the vehicle, with options of 10 Seconds. 2 Minutes and 5 Minutes.
Default Setting: 10 Seconds
4. SETUP MENU
I
I
English
15
To Next Page
Loading...
Need help?
General
