Step 8 of 10
Install the sensor
Locate the sensor (Part C). The sensor has 2 parts. One is
connected to the cable while the other is not.
Mount the sensor that is connected to the cable to the
center of the wall adjacent to the garage door, just above
the garage door. Use the included double sided tape to
secure the sensor. If you have screws, you may use that
instead.
Mount the other sensor (the one NOT connected to a cable)
on center top of the garage door using the double sided
tape. If you have screws, you may use that instead.
Secure the remaining wires along the walls and ceiling using
the included double sided tape to avoid any moving parts
of the door. You can also use other alternatives to secure
the cable such as cable clips or staples.
To Next Page
Loading...
