1.2 USAGE
• Never exceed the protection limit values indicated in specifications for each range of
measurement.
• When the meter is linked to a measurement circuit, do not touch unused terminals.
• When the value scale to be measured is unknown beforehand, set the range selector at the
highest position.
• Before rotating the range selector to change functions, disconnect test leads from the circuit under
test.
• When carrying out measurements on TV or switching power circuits, always remember that there
may be high amplitude voltage pulses at test points which can damage the meter.
• Never perform resistance measurements on live circuits.
• Always be careful when working with voltages above 60V dc or 30V ac rms. Keep fingers behind
the probe barriers while measuring.
-2-
To Next Page
Loading...