1.4 MAINTENANCE
• Before opening the meter, always disconnect test leads from all sources of electric
current.
• For continue protection against fire, replace fuse only with the specified voltage and current
ratings:
F1: F 500mA/250V F2: F 10A/250A
• If any faults or abnormalities are observed, the meter cannot be used and it has to be checked out.
• Never use the meter unless the back cover is in place and fastened fully.
• To clean the meter, use a damp cloth and mild detergent only, do not use abrasives or solvents on it.
-4-
To Next Page
Loading...