NexxTech 6319296 - Page 15

PRESSURE OPERATION
VIEWING PRESSURE AND ALTITUDE INFORMATION
To view pressure or altitude information, press MODE
button. The display will alternate between the sea level
pressure, local pressure and local altitude screens.
PROGRAMMING SEA LEVEL PRESSURE
(Not required if altitude was programmed)
• Press and hold MODE, until the barometric pressure
digits ash.
• Enter the desired sea level pressure value by pressing UP
(▲) or DOWN (▼) buttons. (Press and hold either button
for accelerated digit advance.)
• Press MODE, to conrm sea level value selection.
CHANGING PRESSURE AND ALTITUDE UNITS
• Press MODE as needed, until “LOCAL” pressure is
displayed.
• Press and hold MEM/ HISTORY, until the pressure unit
ashes.
• Change local or sea level pressure units by pressing the
UP (▲) or DOWN (▼) buttons to select the pressure
units. Choose from: inHg, hPa/mBar or mmHg.
• Press MEM/ HISTORY to conrm your selection.
• Press MODE button until the local altitude value is
displayed.
• Press and hold MEM/ HISTORY until the altitude unit
ashes.
• Select the ALTITUDE unit:, meters or feet, by pressing
UP (▲) or DOWN (▼) buttons.
• Press MEM/ HISTORY to conrm your selection.
VIEWING SEA LEVEL PRESSURE HISTORY
• In pressure mode, press MEM/ HISTORY button to enter
the sea level pressure display.
• When the SEA LEVEL is displayed, press MEM/
HISTORY repeatedly to view the sea level pressure
history for the past 24 hours in 1 hour intervals.
•
If no buttons are pressed for 5 seconds, the unit will automatically
return to the default Pressure and Weather Forecast Mode.
15