EasyManua.ls Logo

NexxTech 6319296 - Clock Alarms; Clock Alarms Settings and Management

NexxTech 6319296
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CLOCK ALARMS
There are two time alarms Weekday alarm (W) and Single
day alarm(S) - and one Ice Warning Alarm (PRE-AL).
• If Weekday (W) alarm is activated, it will sound at the set
time and the alarm icon willash Monday through Friday.
• If Single (S) day alarm is activated, it will sound at the set
time and the alarm icon willash only for this specic day
and will not activate on subsequent days.
• If Ice Warning Alarm ( PRE-AL) is activated, it will sound
at the set time and alarm icon will ash once the remote
temperature for Channel One (1) reaches C (32°F) and
below.
NOTE: Ice Warning Alarm can be set only if one or
both - Weekday or Single alarm - are programmed.
SETTING THE WEEKDAY (W) AND
SINGLE DAY (S) ALARMS
• Press ALARM button once to enter into the alarm setting
mode. The default alarm is a Weekday alarm (W). The
abbreviation OFF with a letter W next to it will be
displayed, if the alarm has not been set previously.
• Press and hold ALARM button for two seconds. The hour
digit will ash.
Adjust the hour using UP () or DOWN ( ) buttons.
• Press ALARM button again. The minute digits will ash.
Adjust the minutes using UP () or DOWN (▼) buttons.
• Press ALARM button again to conrm and the weekday
alarm time will be set.
• Set Single (S) day alarm if desired in the same manner.
22

Related product manuals