BATTERY INSTALLATION
When the temperature falls below freezing point 0˚C (32 ˚F),
battery voltage levels will be dropped and this may reduce
the transmission range. For optimum performance, we
recommend using lithium batteries.
NOTE: Install the batteries and select the channel before
mounting the remote sensor.
• Remove the screws from the battery compartment with a
small Phillips screwdriver (not included).
• Set the channel 1 through 3. The switch is located in the
battery compartment. Channel 1 is typically selected if
only one remote sensor is being used.
• Install 2 “AA” size alkaline batteries (not included)
matching the polarities shown in the battery
compartment.
• Select the temperature unit (°C/°F) using a pointed pin.
• Replace the battery compartment door and secure the
screws.
• Secure the remote sensor in the desired location.
MOUNTING
• The remote sensor can be placed on a at surface or
mounted on the wall in a vertical position.
• Use a screw, rather than a nail, for best mounting of the
sensor.
• When mounting the main unit on the wall or vertical
surface, fold the table stand back into the unit.
6
To Next Page
Loading...
