TEMPERATURE/ HUMIDITY WINDOW
ICON STATUS
Searching for the signals from the
remote sensor
Corresponding remote sensor signal
received successfully
No signals received for over 1 hour
SEARCH FOR REMOTE SENSORS
• The main unit can be manually activated to search for
the signals from remote sensors by pressing and holding
DOWN (▼) button.
OPERATION
• To select the indoor/ outdoor temperature and humidity
mode, press UP (▲) or DOWN (▼) until the IN icon
ashes with a beep sound alert.
VIEWING REMOTE (CHANNEL) TEMPERATURE
AND HUMIDITY
Static Display:
• Press the CHANNEL button to select measurements
from different remote sensors, each is MODE to a unique
channel 1, 2 or 3.
Channel Auto-Scan Display:
• To enable an automatic scan of all channels, press
and hold CHANNEL, until the icon is displayed. The
measurements from each remote channel will be
alternately displayed for 5 seconds.
NOTE: the channel auto-scan feature can be active
only if there are more than one remote sensors
operating and are set to different channels.
PROGRAMMING TEMPERATURE IN CELSIUS
OR FAHRENHEIT
• Press and hold MODE button for 3 seconds to toggle the
temperature unit in Celsius (ºC) or Fahrenheit (ºF).
17
To Next Page
