Manual Settings
It is necessary to set the desired TIME ZONE.
TIME ZONE
• Press the MODE button once so that the Day of the Week
abbreviation is displayed to the right of the time;
for example: pm 2:37tu
.
• Select the Time Zone by pressing and holding the UP ( )
button for 3 seconds.
• Keep holding the UP ( ) button until the desired Time Zone
(Pacific, Mountain, Central or Eastern) is highlighted on the
display’s US map, located to the right of the time display and
above the Day of the Week.
• Release the UP( ) button. The Time Zone is now set.
CLOCK
• Press the MODE button for 3 seconds: the year will flash.
Press UP ( ) or DOWN ( ) to set the desired year.
• Once the year is set, press MODE button to confirm and
move to month setting.
• Continue setting month, date, hour, minutes, language
for the day of the week and temperature in Celcius or
Fahrenheit.
• Press MODE when finished to return to normal time display.
Clock Alarms
There are two time alarms - Weekday alarm (W) and Single
day alarm (
S) - and one Ice Warning alarm (PRE-AL).
• If Weekday (
W) alarm is activated, it will sound at the set time
and the alarm icon will flash from Monday through to Friday.
• If Single (
S) day alarm is activated, it will sound at the set time
and the alarm icon will flash only for this specific day and will
not activate on subsequent days.
• If Ice Warning (PRE-AL) alarm is activated, the alarm will
sound at the set time and the alarm icon will flash once the
remote temperature for Channel One (1) reaches 0˚C (32 ˚F)
and below.
NOTE: Ice Warning alarm can be set only if one or both
- Weekday or Single alarm - are programmed.
14
To Next Page
Loading...