Battery Installation
NOTE: When the temperature falls below freezing,
the batteries in the outdoor remote sensor may have
reduced voltage supply and a shorter effective range.
We recommend using lithium batteries at temperatures
of 0˚C (32˚F) and below.
REMOTE SENSOR
NOTE: Install the batteries; select the channel
and temperature display reading in ˚C or ˚F before
mounting the remote sensor.
• Remove the screws from the battery compartment with a
small Phillips screwdriver (not included).
• Set the channel. The switch is located in the battery
compartment. Channel 1 is typically selected if only one
remote sensor is being used.
• Set the desired temperature format (˚C or ˚F) using a
pointed pin.
• Install 2 “AA” size alkaline batteries (not included),
matching the polarities shown in the battery
compartment.
• Replace the battery compartment door and secure the
screws.
• Secure the remote sensor in the desired location.
MAIN UNIT
• Remove the battery compartment door.
• Install 2 “AA” 1.5V alkaline batteries (not included) and
matching the polarity as shown in the battery compartment.
• Replace the battery compartment door.
8
To Next Page
Loading...