NHC Solace - Attaching the Side Rails; Attaching the Mattress Holders

Group ltd
10 11
SECTION 3: UNPACKING AND ASSEMBLY
STEP 18
STEP 21
REPEAT STEP 19
STEP 19
STEP 22
STEP 24 STEP 25
STEP 20
STEP 23
Attaching the Side Rails
Connect the power and use the
handheld control to raise the mattress
platform to a comfortable height for
attaching the side rails.
Remove the bolt from the
headboard, then press the paddle
handle and move down to remove
the side rail slider.
Align and slide the rst rail onto
the mounting ngers attached
to the footboard, ensuring the
rounded edge is at the top.
Follow by sliding the second rail
onto the same set of mounting
ngers.
At the footboard, insert the ngers
into the top rail and the bottom rail
with the pointed end of the slider
positioned upwards.
Fully insert the rail slider into the
footboard.
Repeat the process from Step
19 to attach the side rails on the
opposite side.
Ensure the sliders are rmly in place
by xing the bolt back in place at
the bottom of each slider channel at
the headboard and footboard ends
using the Allen Key.
Use the hand paddles located on
the headboards and footboards
to adjust or lower the side rails
as needed.
STEP 26 STEP 27
Attaching the Mattress Holders
Position the
mattress holders
at regular intervals
along the sides of
the bed frame.
Clip each holder
securely onto the
frame, ensuring
they are evenly
spaced for optimal
mattress support.