5. Insert an SLSC module int
o the same slot as its corresponding RTI-12309 while
firmly holding the RTI-12309 in place until the RTI-12309 is firmly connected to the
module.
6. Repeat steps 4 and 5 for all required RTIs.
7. Tighten the screws for all RTIs and the screws of the upper rear panel of the chassis.
This ensures proper alignment for future connections between modules and RTIs.
Connecting JR1
To connect JR1, complete the following steps.
1. Prepare a terminal wire for JR1 by stripping insulation and installing a Molex Ultra-
Fit crimp terminal following the manufacturer's specifications.
2. Insert a prepared terminal into an appropriate terminal socket of Molex Ultra-Fit 8-
position receptacle housing.
3. Repeat steps 1 and 2 for all appropriate terminals.
4. Insert a receptacle housing into JR1 until the plastic retention latch snaps into
place.
JR1 is keyed to prevent reverse installation of the receptacle housing.
4
ni.com
RTI-12309 Getting Started
To Next Page
Loading...
