Nibe CDS 10 - Connection; Pairing Wireless Accessory; LED Status Indications; Network Connection

Connection
Pairing is performed in the heat pump’s/control module’s
display, select menu 5.4 – Connect wireless units.
CDS 10 should be paired before it is installed on the
wall.
Settings for control are made in menu 1.3.3 - Room
sensor settings.
PAIR YOUR WIRELESS ACCESSORY WITH
YOUR MAIN PRODUCT
Wireless accessory
Main product
MENU 5.4 – CONNECT WIRELESS UNITS
WIRELESS UNITS
Room sensor
CDS10
Add unit
Here, you connect your wireless units. Press "Add unit"
and follow the guide that is launched. You can also check
the connected units’ battery level and signal strength.
CONNECT TO NETWORK
If CDS 10 is flashing red (once every five seconds), it is
searching for a wireless network to connect to. If no
network is found, searching stops after 5 minutes. You
can start a new search by pressing and holding the (SF1)
button on CDS 10 for 3 seconds.
If you need to test the range of the signal, CDS 10 can
be connected to the heat pump at close range and then
moved further away. Wait for at least 30 minutes. The
signal strength can then be read off in the heat
pump’s/control module’s menu system (menu 5.4).
To leave a network and reset CDS 10, press and hold
the (SF1) button for 10 seconds and wait until the red
LED comes on for 5 seconds.
SF1
LED INDICATIONS
ExplanationLED
Factory resetRed LED comes on
for five seconds
Connecting to networkRed LED flashes once
every five seconds
Low batteryRed LED flashes
twice within five
seconds
Lost connection or unit is not
connected to network
Red LED flashes
three times within
five seconds
Identification modeGreen LED flashes
REPEATER RPP 10
If the communication is weak between the main product
and the accessory in a zone, you may need to install a
repeater to amplify the signal between the zones.
1 2
3
1 2
3
Main product Repeater
CDS 10 | GB14