TEMPERATURE
If the house has several climate systems,
this is indicated on the display by a ther-
mometer for each system.
Choose between heating or cooling and
then set the desired temperature in the
next menu "temperature heating/cooling"
in menu 1.1.
Set the temperature (with
room sensor installed and
activated):
heating
Setting range: 5 – 30 °C
Default value: 20
cooling (accessory required)
Setting range: 5 – 30 °C
Default value: 25
Menu
1.1
The value in the display appears as a temperature in °C if the climate system is
controlled by a room sensor.
Caution
A slow heat-releasing heating system, such as for example, underfloor
heating, may not be suitable for control using the heat pump's room
sensor.
To change the room temperature, use the control knob to set the desired tem-
perature in the display. Confirm the new setting by pressing the OK button. The
new temperature is shown on the right-hand side of the symbol in the display.
Setting the temperature (without room sensors activated):
Setting range: -10 to +10
Default value: 0
The display shows the set values for heating (curve offset). To raise or lower the
indoor temperature, increase or reduce the value on the display.
Use the control knob to set a new value. Confirm the new setting by pressing
NIBE F1255Chapter 3 | F1255 – at your service28
To Next Page
Loading...
Need help?
General
