General
This accessory is used to dock a solar installation to a
VVM 500. The solar heat can be used for hot water,
heating the building and pool heating.
NOTE
When this accessory is installed and activated
the temperature in the indoor module vessel is
limited to about 85 °C. Therefore, temperature
settings regarding hot water or heating must
not exceed 85 °C.
Contents
Heating pipe paste2x
Angle connection2x
Insulation pipe2x
Insulation tape1x
Electrical connection, accessory1x
Aluminium tape2x
Cable ties4x
Temperature sensor1x
Temperature sensor for solar panel1x
Clips2x
Copper pipe2x
Cover discs2x
11
English, Installer manual - SCA 30
GB
To Next Page
Loading...