USER GUIDE
9
evoecohomes.co.uk
Full Reset
In some cases, e.g. following a power cut and your heat pump has not
recoverred automatically, your system may need a full reset.
To do this, turn the power supply to your indoor unit o.
Next, turn the power supply to your outdoor unit o using the rotary
isolator, which is a switch next to the heat pump and looks like this:
Leave them both o for 5-10 minutes. Then turn the outdoor unit back on
rst followed by the indoor unit. Your system will now be reset.
If your radiators are not heating to the required temperature, or are not If your radiators are not heating to the required temperature, or are not
heating across its whole surface, you may need to bleed them. This can be heating across its whole surface, you may need to bleed them. This can be
done in exactly the same way as you would bleed radiators previously to done in exactly the same way as you would bleed radiators previously to
installing your heat pump. installing your heat pump.
The key thing to remember after bleeding your radiator is that you will need to The key thing to remember after bleeding your radiator is that you will need to
check the pressure on the system after doing so. If the pressure has dropped check the pressure on the system after doing so. If the pressure has dropped
you will need to repressurise as shown on previous page. you will need to repressurise as shown on previous page.
Inconsistent Radiator Heat
Rotary Isolator:
For Further Assistance Please Call 01329 288118
To Previous Page
Loading...
