Need help?Do you have a question about the Nibe EME 20 and is the answer not in the manual?
General| Brand | Nibe |
|---|---|
| Model | EME 20 |
| Category | Control Unit |
| Language | English |
Manual describes installation and service procedures for specialists.
Explains symbols and CE/IP markings used in the manual.
EME 20 enables communication and control between solar cells and heat pump.
Illustration showing the placement of EME 20 components.
Diagram showing the connection of EME 20 within a system.
Instructions for connecting communication cables to the EME 20.
Instructions on using tools for cable locking in terminal blocks.
Connecting cables to the converter using RS-485 communication.
Settings for other inverters supporting SunSpec with Modbus RTU.
Connecting EME 20 communication board to main product for S1155/S1255.
Connecting EME 20 communication board to control module for SMO S40.
How to connect multiple inverters in parallel to one EME 20.
Information on connecting an optional energy meter.
Details about the DIP switch (S2) on the communication board.
Specify installed accessories for the compatible product.
Settings for how solar electricity surplus is used for heating, hot water, or pool.
Configuration for pulse energy meter input.
EME 20 automatically manages solar energy usage based on settings.
Specifications for the EME 20, including dimensions and part number.
Manual describes installation and service procedures for specialists.
Explains symbols used in the manual.
Explains CE and IP markings.
EME 20 enables communication and control between solar cells and heat pump.
Illustration showing the placement of EME 20 components.
Diagram showing the connection of EME 20 within a system.
Instructions for connecting communication cables to the EME 20.
Instructions on using tools for cable locking in terminal blocks.
Connecting cables to the converter using RS-485 communication.
Settings for other inverters supporting SunSpec with Modbus RTU.
Connecting external accessories to EME 20.
Connecting SMO 20 to EME 20.
Details on electrical connection versions for F1345 models.
Specific connection details for F1345 (2.0) and F1355 models.
Connection details for F1145/F1155 models.
How to connect multiple inverters in parallel to one EME 20.
Information on connecting an optional energy meter.
Details about the DIP switch (S2) on the communication board.
Initial setup guide for EME 20.
Instructions on changing settings via the menu system.
Displays information about available functions and solar accessory modes.
Settings for prioritizing domestic electricity over heating/hot water.
Activating/deactivating accessories like photovoltaic control.
Activating/deactivating accessories for photovoltaic control.
Specifications for the EME 20, including dimensions and part number.
To Next Page
