Nibe VVM 225 User Manual

NOTE
After disconnecting all users none of them can monitor or control your
installation via NIBE Uplink without requesting a new connection string.
TCP/IP SETTINGS
tcp/ip settings4.1.3.8
confirm reset
automatic
ip-address
net mask
gateway
dns
You can set TCP/IP settings for your in-
stallation here.
Automatic setting (DHCP)
Menu
4.1.3.8
1.
Tick “automatic". The installation
now receives the TCP/IP settings
using DHCP.
2.
Mark “confirm" and press the OK
button.
Manual setting
1.
Untick "automatic", you now have access to several setting options.
2.
Mark “ip-address" and press the OK button.
3.
Enter the correct details via the virtual keypad.
4.
Select "OK" and press the OK button.
5.
Repeat 1 - 3 for "net mask", "gateway" and "dns".
6.
Mark “confirm" and press the OK button.
Caution
The installation cannot connect to the internet without the correct
TCP/IP settings. If unsure about applicable settings use the automatic
mode or contact your network administrator (or similar) for further in-
formation.
TIP
All settings made since opening the menu can be reset by marking
"reset" and pressing the OK button.
PROXY SETTINGS
Menu
4.1.3.9
59Chapter 3 | VVM 225 – at your serviceNIBE VVM 225

Nibe VVM 225 Specifications

General

Brand	Nibe
Model	VVM 225
Category	Air Conditioner
Language	English