Nibe VVM 225 User Manual

nibe uplink
internet4.1.3
tcp/ip settings
proxy settings
Here you make the settings for connect-
ing VVM 225 via NIBE Uplink, which uses
the Internet.
NOTE
For these functions to work
the network cable must be
connected.
NIBE UPLINK
request new connection string
serial number
nibe uplink 4.1.3.1
switch off all users
connection string
number of users
Here you can manage the installation's
connection to NIBE Uplink
(nibeuplink.com) and see the number of
users connected to the installation via
the internet.
A connected user has a user account in
NIBE Uplink , which has been given per-
mission to control and/or monitor your
installation.
Request new connection
string
To connect a user account on NIBE Uplink to your installation, you must request
a unique connection code.
Menu
4.1.3.1
1.
Mark “request new connection string" and press the OK button.
2.
The installation now communicates with NIBE Uplink to create a connection
code.
3.
When a connection string has been received, it is shown in this menu at
"connection string" and is valid for 60 minutes.
Disconnect all users
1.
Mark “switch off all users" and press the OK button.
2.
The installation now communicates with NIBE Uplink to release your install-
ation from all users connected via the internet.
NIBE VVM 225Chapter 3 | VVM 225 – at your service58

Nibe VVM 225 Specifications

General

Brand	Nibe
Model	VVM 225
Category	Air Conditioner
Language	English