Nibe VVM 500 - Heating Curve and Advanced Settings

Caution
If the stop time is before the start time it means that the period extends past
midnight. Scheduling always starts on the date that the start time is set for.
Changes of temperature in accommodation take time. For example, short
time periods in combination with underfloor heating will not give a noticeable
difference in room temperature.
advanced
Menu advanced has orange text and is intended for the advanced user. This
menu has several sub-menus.
Menu
1.9
heating curve Setting the heating curve slope.
external adjustment Setting the heat curve offset when the external contact
is connected.
min. flow line temp. Setting minimum permitted flow line temperature.
room sensor settings Settings regarding the room sensor.
own curve Setting own heat curve.
point offset Setting the offset of the heating curve at a specific outdoor
temperature.
heating curve
KHDWLQJ FXUYH 
V\VWHP
RXWGRRU WHPS r&
IORZ WHPSHUDWXUH r&
heating curve
Setting range: 0 - 15
Default value: 9
Menu
1.9.1
NIBE™ VVM 500Chapter 3 | VVM 500 – at your service28