Pag. 12 a 37
LP21/LP22 Installation instructions en Sensors
6 Assembly and electrical installation
In the following section, assembly and electrical installation are described.
Illustrations and technical data on the device
You can find illustrations and technical data on the housing and connections in the sections at the
beginning of this document.
6.1 Assembly on the DIN rail TS35
Assembly conditions
Tools: none
Mounting device: DIN rail TS35 (top hat rail)
Fixing to the top hat rail
1. Place on the device from above with the groove on the top hat rail and lock the clip underneath.
2. Check that it is sitting securely.
→ The detector is ready for commissioning.
To Next Page
Loading...
