To Next PageTo Next Page
Why is my Nice M5BAR Other gate moving in the wrong direction?
If the maneuver is carried out in the opposite direction on your Nice Other, check that the installation selector is in the correct position.
What does it mean when my Nice Other flashes fast 2 times?
If the Nice Other displays fast flashes with a pattern of 2 flashes, a 1-second pause, and then 2 flashes again, this indicates that one or more photocells are blocking the movement at the start of the maneuver. Check for any obstacles.
What does it mean when my Nice M5BAR flashes fast 4 times?
If the Nice Other displays fast flashes with a pattern of 4 flashes, a 1-second pause, and then 4 flashes again, it means that the STOP input was triggered at the start of the maneuver or during the movement itself. You should identify what caused the STOP input to activate.
What does error code I03 mean on my Nice Other?
If the Nice Other displays error code I03, this indicates that the boom experienced excessive friction during movement. Verify the cause of the friction or increase the force level.
What does error code E04 mean on Nice M5BAR?
If the Nice Other displays error code E04, it signifies a lack of communication between the motor sensor and the control unit. Check that the encoder cable is properly connected and in good condition.
Why is my Nice Other not responding to any commands?
If no maneuver is commanded on your Nice Other, check that the gearmotor is being powered with the mains voltage. Also, check whether fuses F1 and F2 are blown; if they are, identify the cause of the failure then replace the fuses with others having the same current rating and characteristics.
How to fix a Nice Other radio transmitter that won't control the gate?
If the Nice Other radio transmitter does not control the gate, and the LED on the transmitter does not light up, check whether the transmitter batteries are exhausted and replace them if necessary.
What to do if Nice M5BAR Other transmitter LED is on but the gate doesn't respond?
If the Nice Other radio transmitter does not control the gate, but the LED on the transmitter lights up, check whether the transmitter has been memorised correctly in the radio receiver.
What does it mean when my Nice Other flashes fast 5 times?
If the Nice Other displays fast flashes with a pattern of 5 flashes, a 1-second pause, and then 5 flashes again, it indicates an error in the internal parameters of the control unit. Disconnect and reconnect the power supply. If the error persists, delete the entire memory and redo the installation.
What does error code E05 mean on the Nice Other?
If the Nice Other displays error code E05, it indicates that the Master and Slave control units are not communicating correctly. You should check that the cable connecting the Master and Slave control units is connected and that the pole markings are observed. Also, ensure that the Slave control unit has been selected and the Master learning phase has been completed.
Warning against children operating controls and keeping remote controls away from them.
Instruction to keep the moving door in sight and away from people/objects until fully closed.
Warning to not start the door downward unless the doorway is clear to prevent entrapment.
Mandatory instruction to read and follow all provided installation guidelines.
Requirement to install opener only on a properly balanced door; seek professional help for repairs.
Instruction for the door to reverse upon contact with a 1-1/2 inch high object after installation.
General instruction to read and follow all user guidelines provided.
Warning against children operating controls and keeping remote controls away from them.
Instruction to keep the moving door in sight and away from people/objects until fully closed.
General
