What to do if the Nice S-BAR Other gate manoeuvre starts but immediately reverses?
If the Nice gate starts a maneuver and then immediately reverses, it may be due to the selected force value being too low for the gate type. First, check for any obstructions. If there are none, try selecting a higher force setting. Also, verify if a safety device connected to the Stop input has been activated.
What to do if Nice S-BAR gate doesn't start and the warning light flashes?
If no maneuver starts and the warning light flashes a few times, count the number of flashes and then refer to “Table 7” to identify the issue.
What to do if Nice Other gate doesn't start and the warning light is off?
If no maneuver starts and the warning light is off, verify that the command is being received. If the command reaches the Step-by-Step input, the corresponding “Sbs” LED should light up. If using the radio transmitter, the “BlueBus” LED should emit two quick flashes.
Why Nice S-BAR radio transmitter doesn't control the gate but the LED lights up?
If the radio transmitter does not control the Nice gate, but the LED on the transmitter lights up, check that the transmitter has been correctly memorized in the radio receiver.
What to do if Nice Other gate doesn't start and the BlueBUS LED doesn't flash?
Check that the gearmotor is receiving power from the mains voltage. Also, inspect fuses F1 and F2. If they are blown, determine the cause of the failure and replace them with fuses that have the same current rating and characteristics as indicated in “Table 9”.
To Next Page
General
