Nice S-BAR

ENGLISH – 23
7.6 MANOEUVRE COUNTER RESETTING
Once maintenance has been performed on the system, the ma-
noeuvre counter must be reset.
L1L2L3L4L5L6L7L8
Flash
Bluebus
Stop
Sbs
Open
Close
L1
L7
40
To do this:
1. press and hold the
o
button until LED “L1” starts ashing
2. release the
o
button when LED “L1” starts ashing
3. press the
p
or
q
button to shift the ashing LED to “L7”,
that is, the “entry LED” for the “Maintenance notice” pa-
rameter
4. press and hold the
o
button. With the
o
button pressed:
– wait roughly 3 seconds until the LED representing the
current level of the “Maintenance notice” parameter
lights up
– press and hold for at least 5 seconds the
p
and
q
buttons then release them. The LED corresponding to
the selected level will emit a series of fast ashes to
signal that the manoeuvre counter has been reset
5. release the
o
button
7.7 MEMORY DELETION
m
The procedure described below restores the con-
trol unit’s default settings. All the custom settings
will be lost.
L1L2L3L4L5L6L7L8
Flash
Bluebus
Stop
Sbs
Open
Close
L1 ... L8
41
To delete the control unit’s memory and restore all the default
settings, proceed as described below:
1. press and hold the
p
and
q
buttons until the program-
ming LEDs “L1-L8” light up (after roughly 3 seconds)
2. release the buttons.
LEDs “L1” and “L2” will start ashing at the end of the proce-
dure.
l
With this procedure it is possible to also delete any
errors left in the memory.
l
This procedure does not cancel the parameter rel-
ative to the motor’s rotation direction and the num-
ber of manoeuvres executed.
TROUBLESHOOTING...
(troubleshooting guide)
8
8 TROUBLESHOOTING GUIDE
8.1 TROUBLESHOOTING
The table below contains useful instructions to resolve any malfunctions or errors that may occur during installation or in case of a
fault.
Table 8
TROUBLESHOOTING
Problems Recommended checks
The radio transmitter does not
control the gate and the LED on the
transmitter does not light up
Check whether the transmitter batteries are exhausted and replace them if necessary.
The radio transmitter does not
control the gate but the LED on the
transmitter lights up
Check whether the transmitter has been memorised correctly in the radio receiver.
No manoeuvre starts and the
“BlueBUS” LED does not ash
Check that the gearmotor is being powered with the mains voltage
Check whether fuses F1 and F2 are blown; if they are, identify the cause of the failure then
replace the fuses with others having the same current rating and characteristics, according
to that indicated in “Table 9”.
No manoeuvre starts and the warning
light is off
Check that the command is actually received. If it reaches the Step-by-Step input, the
corresponding “Sbs” LED must light up; if instead the radio transmitter is used, the
“BlueBus” LED must emit two fast ashes.
No manoeuvre starts and the warning
light ashes a few times
Count the number of ashes and check the corresponding value in “Table 7”.
The manoeuvre starts but is
immediately followed by a reverse run
The selected force value may be too low to move the type of gate. Check whether there are
any obstacles and, if necessary, select a higher force.
Check whether a safety device connected to the Stop input has tripped.