To Next PageTo Next Page
Need help?Do you have a question about the Nice MBar Series and is the answer not in the manual?
General| Motor voltage | 24 Vdc |
|---|---|
| Protection level | IP54 |
| Type | Barrier gate |
| Power supply | 230V AC, 50Hz |
| Opening time | 1.5 seconds |
| Operating temperature | -20°C to +50°C |
| Application | Vehicle access control |
Important safety warnings for personal safety and correct installation.
Warnings regarding product suitability, installation environment, and safe practices.
Specific warnings for product compliance with European directives.
Criteria for installation compliance with essential requirements of CE directives.
Checks before starting installation, including material condition and environment suitability.
Ensures product use is compatible with specifications and intended use.
Estimates product lifetime based on manoeuvre cycles and severity index.
Shows components and general layout for an automation system.
Procedure to change the factory setting for closing direction.
Guide to identify correct holes for spring anchoring based on accessories.
Instructions for mounting the barrier, with or without an existing support.
Steps for fixing the barrier to an already existing solid surface.
Steps for installing a foundation plate for the barrier.
Detailed instructions for assembling and installing the barrier pole.
Procedure for assembling the pole support onto the motor shaft.
Instructions for assembling 3m and 5m poles, including insertions and impact rubber.
Instructions for assembling 6m and 9m poles using extensions and joints.
Procedure to manually release and lock the gearmotor in case of power failure.
Detailed steps for operating the locking cylinder for manual release.
Procedure to adjust the mechanical stop screws for pole alignment.
Instructions for balancing the pole using the spring tension.
Specific procedure for balancing poles of M3BAR, M5BAR, and M7BAR models.
Specific procedure for balancing poles of the LBAR model.
Details on various outputs like LIGHT, FLASH, BLUEBUS, STOP, etc.
Procedure for initial start-up and checking electrical connections.
Information on factory-set programmable functions.
Process for the control unit to recognize connected Bluebus and Stop devices.
Procedure for learning pole opening and closing limit positions.
Verifying correct pole movement and deceleration during opening/closing.
Instructions for connecting an optional radio receiver to the control unit.
Steps to install and connect optional pole lights.
Instructions for connecting optional LED flashing or traffic lights.
Details on connecting other devices like Oview, buffer battery, and Solemyo.
Information on connecting and using the Oview programming unit.
Instructions for installing and connecting the PS224 buffer battery.
Instructions for connecting the Solemyo photovoltaic supply system.
Detailed tests to ensure system safety and correct operation.
Final steps to complete automation setup and handover to the owner.
Programming ON-OFF functions using the control unit keys.
Adjusting parameters using the control unit keys or Oview programmer.
Procedure to reset the control unit to factory settings.
Description of special functions like 'Always open', 'Move anyway', and 'Maintenance notification'.
Function to keep the barrier permanently open.
Enables barrier operation in 'hold-to-run' mode during safety device malfunctions.
Function to notify when maintenance checks are due.
How to check the number of performed manoeuvres using the Oview programmer.
Procedure to reset the manoeuvre counter after maintenance.
Procedure for adding or removing devices connected to the BlueBus.
Explanation of the Bluebus system for connecting devices.
Information on installing and configuring photocells.
Connecting digital selectors and transponder readers.
Details on connecting safety devices to the STOP input.
Information on diagnostic signals from control unit LEDs.
Table detailing LED signals, their causes, and solutions.
Interpreting flashing light signals for fault diagnosis.
Details on the loop detector function for metal mass detection.
How the loop detector works and its operating modes.
Instructions for installing magnetic loops.
Configuration for automating two counterposed barriers.
Electrical connections for Master-Slave mode setup.
