Need help?Do you have a question about the Nice MBar and is the answer not in the manual?
General| Brand | Nice |
|---|---|
| Model | MBar |
| Category | Gate Opener |
| Language | English |
Assign a name to the automation for identification purposes.
Define device classification and network address for control and identification.
Assign devices to groups for simultaneous command execution.
View firmware, hardware, and serial number of the device.
Restrict access to programming functions with user and installer passwords.
Procedures for setting up control unit functions and connected devices.
Learn devices and measure limit positions for manoeuvre calculation.
Program specific pole positions for opening and closing maneuvers.
Configure motor rotation direction and deceleration points.
Set braking force and configure master-slave barrier operation.
Delete data and view barrier version information.
Configure automatic closure and wait time between manoeuvres.
Control automation behavior after safety devices are triggered.
Determine restart trigger and program wait time for closing.
Manage automation behavior during power failures.
Adjust motor force and obstacle detection sensitivity.
Set manoeuvre speeds and define exclusion limits.
Configure motor speeds for opening and closing manoeuvres.
Adjust motor force and speed for initial manoeuvre start.
Configure response to forced opening attempts when closed.
Configure flashing time for manoeuvre start indication.
Reduce power consumption using stand-by modes.
Disable automation operation or control unit keys.
Enable opening maneuver without safety devices during power failure.
Assign commands and operating modes to control unit inputs.
Control courtesy light activation and duration.
Configure step-by-step operation for apartment block transmitters.
Manage stop commands and release operations.
Configure automatic opening, loop detectors, and emergency stop.
Configure loop power, calibration, sensitivity, activation, and mode.
Select operating modes for step-by-step, partial open, open, close, and stop commands.
Configure modes for stop, photo, and alternative commands.
Configure outputs for traffic lights and gate status indication.
Configure outputs for flasher signals and courtesy lighting.
Configure outputs for red traffic lights and always-on indicators.
Configure green, one-way, and two-way alternating traffic lights.
Configure radio channel and Output 1 flash functions.
Configure flashing, courtesy, electric lock, and suction cup outputs.
Configure traffic lights, loop status, and siren outputs.
Configure fan activation and timing for lock, suction cup, and courtesy light.
Display operating status of inputs, outputs, and automation position.
Check status of stop, bluebus, positions, encoder, outputs, alarms, and overtravel.
Monitor motor parameters, general diagnostics, and bluebus device status.
Set alarm thresholds, check, and delete maintenance counts.
Access event logs, update firmware, and manage user permissions.
To Next Page