EasyManuals Logo
Home>Nice>Control Systems>MORX

Nice MORX Instructions And Warnings For Installation And Use

Nice MORX
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3 – English
EN
TABLE 2 - EDS / EDSI keypads only
This table is divided into two sections. Each indicates the connections between: a) the number of keypads connected to the MORX decoder;
b) the programming mode; c) the maximum number of combinations you can obtain; d) the addressing of each keypad.
Programming
EASY
First keypad Second keypad Third keypad Fourth keypad
jumper position:
addresses all equal (
1
)
address
– 1 –
1
2
3
4
address
– 1 –
1
2
3
4
address
– 1 –
1
2
3
4
address
– 1 –
1
2
3
4
number of combinations
up to 2 (
and ) up to 2 ( and ) up to 2 ( and ) up to 2 ( and )
First keypad Second keypad ––– –––
jumper position:
addresses all different (
2
)
address
– 1 –
1
2
3
4
address
– 2 –
1
2
3
4
––– –––
number of combinations
no more than 1 (
/ ) no more than 1 ( / )
––– –––
Programming
PROFESSIONAL
First keypad Second keypad Third keypad Fourth keypad
jumper position:
addresses all equal (
1
)
address
– 1 –
1
2
3
4
address
– 1 –
1
2
3
4
address
– 1 –
1
2
3
4
address
– 1 –
1
2
3
4
number of combinations (
3
) up to 255 up to 255 up to 255 up to 255
First keypad Second keypad Third keypad Fourth keypad
jumper position:
addresses all different (
2
)
address
– 1 –
1
2
3
4
address
– 2 –
1
2
3
4
address
– 3 –
1
2
3
4
address
– 4 –
1
2
3
4
number of combinations (
3
) up to 255 (distributed among all keypads in the system)
NOTE - VERY IMPORTANT!
(1) – If you select this type of addressing, a combination can be programmed on any keypad connected to the MORX. When the system is being used, the combination
can then be entered on any of the keypads connected to the MORX.
(2)Caution! – Each keypad must have a different address from the other keypads. • If you select this type of addressing, each combination must be programmed on a
specific keypad connected to the MORX. When the system is being used, any given combination can only be used on the same keypad with which it was programmed.
(3) – The maximum number of combinations is also determined by the type of BM memory card and whether a second card is present (see Chapter 2).

Other manuals for Nice MORX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nice MORX and is the answer not in the manual?

Nice MORX Specifications

General IconGeneral
BrandNice
ModelMORX
CategoryControl Systems
LanguageEnglish

Related product manuals