EN
English – 4
To use Ovie w as a fixed control fo r automat ions, it mus t be install ed in a su it-
able location, out of the reach of children and at a height of at least 150 cm
from the ground.
To mo unt the dev ic e o n a wall, use t he su pp or t s up plied in the pack, as sh ow n
in fig. 2.
Then connect Oview to the automation with reference to the instructions in
Chapter 3.
––– OBLIGATIONS FOR THE INSTALLER –––
IMPORTANT – After installing and programming Oview as a control
device, the installer must provide the client with the part of this manual
entitled “User Manual”.
Also, if the installer intends the enable the client access to a number of
programming functions, the relative information on these functions must
also be supplied, as specified in the CD “Programmable functions of
devices with BusT4 connector”.
OVIEW INSTALLATION
AS A CONTROL DEVICE
2
2
To Next Page
Loading...
Need help?
General
